Rosa A. Ostergaard Gutter Guards June 22nd, 2018 - 09:36:11
You will need ladders a hammer tape measure four foot level drill with metal bits rivets and rivet gun gutter caulking gutter spikes and ferrules or roof gutter straps. I place one nail every two feet on center starting a couple of inches in from the ends and over the downspout outlet(s) openings. First install both the end caps with caulking and then add the downspout outlets riveting each one in place. If youre using a single ten foot gutter a downspout at one end should be more than sufficient. Gutters may be hung using either nails and ferrules or roof straps.
Spikes come in both white and dark brown pre-finished head colors to match the gutters. Roof straps are for me the least desirable mounting method. They are used when the fascia board is weak or non-existent. The strap is nailed down into the roofing under the bottom shingle and hangs off the edge of the eave. The gutter is placed inside the strap assembly and the strap is locked into place. I have seen these straps face nailed into the bottom course of shingles but this is highly undesirable and will surely leak as the year pass.
Attach the downspout to the gutter outlet with two small galvanized self tapping sheet metal screws. You may want to remove the downspout for cleaning one day. Now using the downspout bracket you riveted to the pipe earlier bend the flat bracket tightly around the downspout pipe and bend the two ends outward flat against the house siding. Using galvanized roofing nails nail the straps securely to the main building. A minimum of two straps is required with one at the top where the downspout first contacts the house and the other just above the bottom elbow.
Do not drive the spikes all the way. Proceed along the gutter in two foot incremental spaces until reaching the opposite end of the gutter. Get down off your ladder and look at the gutter. Does it tip ever so slightly towards the downspout hole? If it is really noticeable it may be too much tilt. Now is the time to adjust the gutter slope before you drive the spikes completely into the wood. If you are happy with the gutter go ahead and drive the spikes flush with the gutter but do not compress the gutter or ferrules.